SSG-10/VSR-10 TDC Aluminum Drill Tool

This SSG-10/VSR-10 TDC Aluminum Drill Tool saves you a lot of time drilling the perfect centered hole for your TDC setup.

• 1x SSG-10/VSR-10 TDC Aluminum Drill Tool
• 1x Screw to temporary tighten the tool inside the outer barrel

Installation notes:

1. Uninstall your outer barrel
2. Uninstall everything from your outer barrel
3. Put the drill tool inside the outer barrel
4. Place the drill tool where your hopup normally is
5. Make sure you see the text (THIS SIDE UP)
6. Use the supplied screw and tighten it in your outer barrel and drill tool
7. Use a sharp metal 5mm drill (We use Bosch Series) and drill a hole
8. Uninstall the drill tool
9. Leave as is, or drill a bigger hole with a bigger drill